R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

42
Enabling BFD for RIP FRR
By default, RIP FRR does not use BFD to detect primary link failures. To speed up RIP convergence, enable
BFD single-hop echo detection for RIP FRR to detect primary link failures.
To configure BFD for RIP FRR:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the source IP
address of BFD echo packets.
bfd echo-source-ip ip-address
By default, the source IP address of
BFD echo packets is not
configured.
3. Enter interface view.
interface interface-type
interface-number
N/A
4. Enable BFD for RIP FRR.
rip primary-path-detect bfd echo
By default, BFD for RIP FRR is
disabled.
Displaying and maintaining RIP
Execute display commands in any view and execute reset commands in user view.
Task Command
Display RIP current status and configuration
information.
display rip [ process-id ]
Display active routes in RIP database.
display rip process-id database [ ip-address
{ mask-length | mask } ]
Display RIP interface information.
display rip process-id interface [ interface-type
interface-number ]
Display routing information about a specified RIP
process.
display rip process-id route [ ip-address { mask-length
| mask } [ verbose ] | peer ip-address | statistics ]
Reset a RIP process. reset rip process-id process
Clear the statistics for a RIP process. reset rip process-id statistics
RIP configuration examples
Configuring basic RIP
Network requirements
As shown in Figure 7, enable RIPv2 on all interfaces on Router A and Router B. Configure Router B to not
advertise route 10.2.1.0/24 to Router A, and to accept only route 2.1.1.0/24 from Router A.