R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

OSPF configuration task list

To run OSPF, you must first enable OSPF on the router. Make a proper configuration plan to avoid

incorrect settings that can result in route blocking and routing loops.

To configure OSPF, perform the following tasks:

Tasks at a

lance

(Required.) Enabling OSPF

(Optional.) Configuring OSPF areas:

• Configuring a stub area

• Configuring an NSSA area

• Configuring a virtual link

(Optional.) Configuring OSPF network types:

• Configuring the broadcast network type for an interface

• Configuring the NBMA network type for an interface

• Configuring the P2MP network type for an interface

• Configuring the P2P network type for an interface

(Optional.) Configuring OSPF route control:

• Configuring OSPF route summarization

{ Configuring route summarization on an ABR

{ Configuring route summarization when redistributing routes into OSPF on an ASBR

• Configuring received OSPF route filtering

• Configuring Type-3 LSA filtering

• Configuring an OSPF cost for an interface

• Configuring the maximum number of ECMP routes

• Configuring OSPF preference

• Configuring OSPF route redistribution

{ Configuring OSPF to redistribute routes from another routing protocol

{ Configuring OSPF to redistribute a default route

{ Configuring default parameters for redistributed routes

• Advertising a host route