R0106-HP MSR Router Series Layer 3 - IP Services Command Reference(V7)

150
<Sysname> display nat session verbose slot 1
Slot 1:
Initiator:
Source IP/port: 192.168.1.18/1877
Destination IP/port: 192.168.1.55/22
DS-Lite tunnel peer: -
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: TCP(6)
Responder:
Source IP/port: 192.168.1.55/22
Destination IP/port: 192.168.1.18/1877
DS-Lite tunnel peer: -
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: TCP(6)
State: TCP_SYN_SENT
Application: SSH
Start time: 2011-07-29 19:12:36 TTL: 28s
Interface(in) : GigabitEthernet2/1/1
Interface(out): GigabitEthernet2/1/2
Initiator->Responder: 1 packets 48 bytes
Responder->Initiator: 0 packets 0 bytes
Total sessions found: 1
Table 40 Command output
Field Descri
p
tion
Initiator Session information about an initiator.
Responder Session information about a responder.
Protocol Transport layer protocol type, DCCP, ICMP, Raw IP, SCTP, TCP, UDP, or UDP-Lite.
DS-Lite tunnel peer
Remote peer address of the DS-Lite tunnel that the NAT session uses. If no remote peer
address is specified, this field displays a hyphen (-).
VPN instance/VLAN
ID/VLL ID
MPLS L3VPN instance to which the session belongs.
VLAN ID to which the session belongs for Layer 2 forwarding.
INLINE to which the session belongs for Layer 2 forwarding.
If a setting is not specified, this field displays a hyphen (-).
State NAT session status.
Application
Application layer protocol type: FTP or DNS.
This field displays unknown for the protocol type of non-well-known ports.
Start time Time when the session starts.
TTL NAT session lifetime in seconds.
Interface(in) Input interface.
Interface(out) Output interface.
Initiator->Responder Number of packets and packet bytes from the initiator to the responder.
Responder->Initiator Number of packets and packet bytes from the responder to the initiator.