R0106-HP MSR Router Series Layer 3 - IP Services Command Reference(V7)

362
Field Description
Idle time
Remaining time in minutes for the mapping between IPv6 address of
the B4 router and tunnel ID.
When the mapping ages out but is still applied by a session, this field
displays hyphens (--).
display interface tunnel
Use display interface tunnel to display information about tunnel interfaces, including the source address,
destination address, and tunnel mode.
Syntax
display interface [ tunnel [ number ] ] [ brief [ description | down ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
number: Specifies the number of a tunnel interface.
brief: Displays brief interface information. If you do not specify this keyword, this command displays
detailed interface information.
description: Displays complete interface descriptions. If you do not specify this keyword, this command
displays only the first 27 characters of interface descriptions.
down: Displays information about interfaces in the physical state of DOWN and the causes. If you do not
specify this keyword, this command displays information about interfaces in all states.
Usage guidelines
If you do not specify the tunnel keyword, this command displays information about all interfaces on the
device.
If you specify the tunnel keyword without the number argument, this command displays information
about all existing tunnel interfaces.
Examples
# Display detailed information about interface Tunnel 1.
<Sysname> display interface tunnel 1
Tunnel1
Current state: UP
Line protocol state: UP
Description: Tunnel1 Interface
Bandwidth: 64kbps
Maximum Transmit Unit: 1476
Internet Address is 10.1.2.1/24 Primary
Tunnel source 2002::1:1 (Vlan-interface10), destination 2001::2:1
Tunnel keepalive enabled, Period(50 s), Retries(3)