R0106-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V7)

124
Ste
p
Command Remarks
5. Configure load sharing
NAT Server.
nat server protocol pro-type global
{ { global-address | current-interface | interface
interface-type interface-number } { global-port |
global-port1 global-port2 } | global-address1
global-address2 global-port } [ vpn-instance
global-name ] inside server-group
group-number [ vpn-instance local-name ] [ acl
acl-number ]
By default, no internal
server exists.
You can configure
multiple load sharing
internal servers on an
interface.
Configuring NAT444
NAT444 provides outbound address translation, and it is configured on the interface connected to the
public network.
Configuring static NAT444
Static NAT444 is applicable when the private IP addresses are fixed.
To configure static NAT444:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a NAT port block
group, and enter its view.
nat port-block-group
group-number
By default, no port block group exists.
3. Add a private IP address
member to the port block
group.
local-ip-address start-address
end-address
By default, no private IP address member
exists in the port block group.
You can add multiple private IP address
members to one port block group, but they
cannot overlap.
4. Add a public IP address
member to the port block
group.
global-ip-pool start-address
end-address
By default, no public IP address member
exists in the port block group.
You can add multiple public IP address
members to one port block group, but they
cannot overlap.
5. (Optional.) Configure the
port range for the public IP
addresses.
port-range start-port-number
end-port-number
By default, the port range is 1 to 65535.
6. Set the port block size.
block-size block-size By default, the port block size is 256.
7. Return to system view.
quit N/A
8. Enter interface view.
interface interface-type
interface-number
N/A
9. Apply the port block group
to the outbound direction
of the interface.
nat outbound port-block-group
group-number
By default, no port block group is applied
to the interface.
You can apply multiple port block groups
to one interface.
10. Return to system view.
quit
N/A