R0106-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V7)

138
Verifying the configuration
# Verify that the host on the external network can access the internal servers by using the NAT addresses.
(Details not shown.)
# Display all NAT configuration and statistics.
[Router] display nat all
NAT internal server information:
There are 4 internal servers.
Interface: GigabitEthernet2/1/2
Protocol: 6(TCP)
Global IP/port: 202.38.1.1/21
Local IP/port: 10.110.10.3/21
Interface: GigabitEthernet2/1/2
Protocol: 6(TCP)
Global IP/port: 202.38.1.1/25
Local IP/port: 10.110.10.4/25
Interface: GigabitEthernet2/1/2
Protocol: 6(TCP)
Global IP/port: 202.38.1.1/80
Local IP/port: 10.110.10.1/80
Interface: GigabitEthernet2/1/2
Protocol: 6(TCP)
Global IP/port: 202.38.1.1/8080
Local IP/port: 10.110.10.2/80
NAT logging:
Log enable : Disabled
Flow-begin : Disabled
Flow-end : Disabled
Flow-active : Disabled
Port-block-assign : Disabled
Port-block-withdraw : Disabled
Alarm : Disabled
NAT mapping behavior:
Mapping mode: Address and Port-Dependent
ACL : ---
NAT ALG:
DNS : Enabled
FTP : Enabled
H323 : Enabled
ICMP-ERROR : Enabled
ILS : Enabled
MGCP : Enabled
NBT : Enabled