R0106-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V7)

162
# Configure outbound NAT444 on interface GigabitEthernet 2/1/2.
[Router] interface gigabitethernet 2/1/2
[Router-GigabitEthernet2/1/2] nat outbound 2000 address-group 0
[Router-GigabitEthernet2/1/2] quit
Verifying the configuration
# Verify that Host A can access external servers, but Host B and Host C cannot. (Details not shown.)
# Display all NAT configuration and statistics.
[Router]display nat all
NAT address group information:
There are 1 NAT address groups.
Address group 0:
Port range: 1024-65535
Port block size: 300
Extended block number: 1
Address iniformation:
Start address End address
202.38.1.2 202.38.1.3
NAT outbound information:
There are 1 NAT outbound rules.
Interface: GigabitEthernet2/1/2
ACL: 2000 Address group: 0 Port-preserved: N
NO-PAT: N Reversible: N
NAT logging:
Log enable : Disabled
Flow-begin : Disabled
Flow-end : Disabled
Flow-active : Disabled
Port-block-assign : Disabled
Port-block-withdraw : Disabled
Alarm : Disabled
NAT mapping behavior:
Mapping mode: Address and Port-Dependent
ACL : ---
NAT ALG:
DNS : Enabled
FTP : Enabled
H323 : Enabled
ICMP-ERROR : Enabled
ILS : Enabled
MGCP : Enabled
NBT : Enabled
PPTP : Enabled
RTSP : Enabled