R0106-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V7)

ManualsBrandsHP ManualsNetwork HardwareHP MSR3024 TAA-compliant AC Router

291

292

293

294

295

296

297

298

299

300

287

# Specify the IP address of Serial 2/2/1 on Router B as the destination address for the tunnel

interface.

[RouterA-Tunnel1] destination 3.1.1.1

[RouterA-Tunnel1] quit

# Configure a static route destined for the IP network Group 2 through the tunnel interface.

[RouterA] ip route-static 10.1.3.0 255.255.255.0 tunnel 1

• Configure Router B:

# Specify an IPv4 address for GigabitEthernet 2/1/1.

<RouterB> system-view

[RouterB] interface gigabitethernet 2/1/1

[RouterB-GigabitEthernet2/1/1] ip address 10.1.3.1 255.255.255.0

[RouterB-GigabitEthernet2/1/1] quit

# Specify an IPv4 address for Serial 2/2/1, which is the physical interface of the tunnel.

[RouterB] interface serial 2/2/1

[RouterB-Serial2/2/1] ip address 3.1.1.1 255.255.255.0

[RouterB-Serial2/2/1] quit

# Create an IPv4 over IPv4 tunnel interface tunnel 2.

[RouterB] interface tunnel 2 mode ipv4-ipv4

# Specify an IPv4 address for the tunnel interface.

[RouterB-Tunnel2] ip address 10.1.2.2 255.255.255.0

# Specify the IP address of Serial 2/2/1 as the source address for the tunnel interface.

[RouterB-Tunnel2] source 3.1.1.1

# Specify the IP address of Serial 2/2/0 on Router A as a destination address for the tunnel

interface.

[RouterB-Tunnel2] destination 2.1.1.1

[RouterB-Tunnel2] quit

# Configure a static route destined for the IP network Group 1 through the tunnel interface.

[RouterB] ip route-static 10.1.1.0 255.255.255.0 tunnel 2

Verifying the configuration

# Use the display interface tunnel command to display the status of the tunnel interfaces on Router A and

Router B. The output shows that the tunnel interfaces are up. (Details not shown.)

# Ping the IPv4 address of the peer interface GigabitEthernet 2/1/1 from each router. The following

shows the output on Router A.

[RouterA] ping -a 10.1.1.1 10.1.3.1

Ping 10.1.3.1 (10.1.3.1) from 10.1.1.1: 56 data bytes, press CTRL_C to break

56 bytes from 10.1.3.1: icmp_seq=0 ttl=255 time=2.000 ms

56 bytes from 10.1.3.1: icmp_seq=1 ttl=255 time=1.000 ms

56 bytes from 10.1.3.1: icmp_seq=2 ttl=255 time=0.000 ms

56 bytes from 10.1.3.1: icmp_seq=3 ttl=255 time=1.000 ms

56 bytes from 10.1.3.1: icmp_seq=4 ttl=255 time=1.000 ms

--- Ping statistics for 10.1.3.1 ---

5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss

round-trip min/avg/max/std-dev = 0.000/1.000/2.000/0.632 ms