R0106-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V7)

304
Configuring a GRE over IPv6 tunnel
Follow these guidelines when you configure a GRE over IPv6 tunnel:
• You must configure the tunnel source address and destination address at both ends of a tunnel. The
tunnel source or destination address at one end must be the tunnel destination or source address at
the other end.
• HP recommends not configuring the same tunnel source and destination addresses for local tunnel
interfaces that use the same tunnel mode.
• You can enable or disable the GRE checksum function at each end of a tunnel. If GRE checksum is
enabled at a tunnel end, the tunnel end sends packets carrying the checksum to the peer end. A
tunnel end checks the GRE checksum of a received packet if the packet carries a GRE checksum,
whether or not the tunnel end is enabled with the GRE checksum function or not.
• To ensure correct packet forwarding, identify whether the destination network of packets and the IP
address of the local tunnel interface are on the same subnet. If not, configure a route reaching the
destination network through the tunnel interface. You can configure the route by using the following
methods:
{ Configure a static route, using the local tunnel interface as the outgoing interface of the route.
{ Enable a dynamic routing protocol on both the tunnel interface and the interface connecting the
private network. This allows the dynamic routing protocol to establish a routing entry with the
tunnel interface as the outgoing interface.
• The IP address of the tunnel interface and the tunnel destination address configured on the tunnel
interface must be in different subnets.
For information about tunnel interfaces, the interface tunnel, source, destination, and tunnel discard
ipv4-compatible-packet commands, and additional configuration commands on a tunnel interface, see
"Configuring tunneling."
To configure a GRE over IPv6 tunnel:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a GRE over IPv6 tunnel
interface and enter its view.
interface tunnel interface-number
mode gre ipv6
By default, the device has no
tunnel interface.
You must configure the same
tunnel mode on both ends of a
tunnel. Otherwise, packet delivery
might fail.
3. Configure an IPv4 or IPv6
address for the tunnel interface.
For information about how to
assign an IPv4 address to an
interface, see "Configuring IP
addressing."
For information about how to
assign an IPv6 address to an
interface, see "Configuring basic
IPv6 settings."
By default, no IPv4 or IPv6 address
is configured for a tunnel interface.
When the passenger protocol is
IPv4, configure an IPv4 address for
the tunnel interface. When the
passenger protocol is IPv6,
configure an IPv6 address for the
tunnel interface.