R0106-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V7)

327
Ste
p
Command
Remarks
6. (Optional.) Set the source UDP
port number of ADVPN
packets.
advpn source-port port-number
By default, the source UDP port
number of ADVPN packets is
18001.
This command is available when
the tunnel mode is UDP.
If the vam client command
configured on the tunnel interface
has the compatible keyword, the
tunnel interface must have a
different source UDP port number
from other tunnel interfaces.
7. Bind a VAM client to the tunnel
interface.
Bind an IPv4 VAM client to the
tunnel interface:
vam client client-name
[ compatible advpn0 ]
Bind an IPv6 VAM client to the
tunnel interface:
vam ipv6 client client-name
By default, no VAM client is bound
to an ADVPN tunnel interface.
A VAM client can be bound to only
one IPv4 ADVPN tunnel interface.
A VAM client can be bound to only
one IPv6 ADVPN tunnel interface.
8. (Optional.) Configure a private
network for the tunnel
interface.
Configure a private IPv4
network for the tunnel interface:
advpn network ip-address
{ mask-length | mask }
[ preference preference-value ]
Configure a private IPv6
network for the tunnel interface:
advpn ipv6 network
prefix/prefix-length
[ preference preference-value ]
By default:
No private network is
configured for the tunnel
interface.
The preference of the private
network route is higher than
other dynamic routing
protocols, and is lower than a
static route.
9. (Optional.) Set the keepalive
interval and keepalive attempts
for the tunnel interface.
keepalive interval time-interval
retry retry-times
By default, the keepalive interval is
180 seconds, and the keepalive
attempts are 3.
The keepalive interval and
keepalive attempts must be the
same on the tunnel interfaces in an
ADVPN domain.
10. (Optional.) Set the idle timeout
for the spoke-spoke tunnel.
dvpn session idle-time time-interval
By default, the idle timeout is 600
seconds.
The new idle timeout setting
applies to both existing and
subsequently established
spoke-spoke tunnels.
11. (Optional.) Set the dumb time
for the tunnel interface.
dvpn session dumb-time
time-interval
By default, the dumb time is 120
seconds.
The new dumb time setting only
applies to subsequently
established tunnels.
For more information about tunnel interface configurations and commands, see Layer 3—IP Services
Configuration Guide and Layer 3—IP Services Command Reference.