R0106-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V7)

377
# Specify hub private addresses.
[PrimaryServer-vam-server-domain-abc-hub-group-0] hub ipv6 private-address
192:168::1
[PrimaryServer-vam-server-domain-abc-hub-group-0] hub ipv6 private-address
192:168::2
[PrimaryServer-vam-server-domain-abc-hub-group-0] hub ipv6 private-address
192:168::3
[PrimaryServer-vam-server-domain-abc-hub-group-0] quit
# Create hub group 1.
[PrimaryServer-vam-server-domain-abc] hub-group 1
# Specify hub private addresses.
[PrimaryServer-vam-server-domain-abc-hub-group-1] hub ipv6 private-address
192:168:1::1
[PrimaryServer-vam-server-domain-abc-hub-group-1] hub ipv6 private-address
192:168:1::2
# Specify a spoke private network.
[PrimaryServer-vam-server-domain-abc-hub-group-1] spoke ipv6 private-address
network 192:168:1::0 64
# Allow establishing spoke-spoke tunnels.
[PrimaryServer-vam-server-domain-abc-hub-group-1] shortcut ipv6 interest all
[PrimaryServer-vam-server-domain-abc-hub-group-1] quit
# Create hub group 2.
[PrimaryServer-vam-server-domain-abc] hub-group 2
# Specify the hub private address.
[PrimaryServer-vam-server-domain-abc-hub-group-2] hub ipv6 private-address
192:168:2::1
# Specify a spoke private network.
[PrimaryServer-vam-server-domain-abc-hub-group-2] spoke ipv6 private-address
network 192:168:2::0 64
[PrimaryServer-vam-server-domain-abc-hub-group-2] quit
# Set the pre-shared key to 123456.
[PrimaryServer-vam-server-domain-abc] pre-shared-key simple 123456
# Set the authentication mode to CHAP.
[PrimaryServer-vam-server-domain-abc] authentication-method chap
# Enable the VAM server for the ADVPN domain.
[PrimaryServer-vam-server-domain-abc] server enable
[PrimaryServer-vam-server-domain-abc] quit
Configuring the secondary VAM server
# Configure the secondary VAM server in the same way that the primary server is configured. (Details
not shown.)
Configuring Hub 1
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure the VAM client:
# Create VAM client hub1Group0.
<Hub1> system-view