R0106-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V7)

40
Option Option name
Corresponding
command
Recommended option
command
p
arameters
46
NetBIOS over TCP/IP Node
Type Option
netbios-type hex
66 TFTP server name tftp-server ascii
67 Boot file name bootfile-name ascii
43 Vendor Specific Information N/A hex
Enabling DHCP
You must enable DHCP to validate other DHCP configurations.
To enable DHCP:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable DHCP.
dhcp enable By default, DHCP is disabled.
Enabling the DHCP server on an interface
Perform this task to enable the DHCP server on an interface. Upon receiving a DHCP request on the
interface, the DHCP server assigns an IP address and other configuration parameters from the DHCP
address pool to the DHCP client.
To enable the DHCP server on an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Enable the DHCP server on the
interface.
dhcp select server
By default, the DHCP
server on the interface
is enabled.
Applying an address pool on an interface
Perform this task to apply a DHCP address pool on an interface. Upon receiving a DHCP request from the
interface, the DHCP server assigns the statically bound IP address and configuration parameters from the
address pool that contains the static binding. If no static binding is found for the requesting client, the
DHCP server selects the applied address pool for address and configuration parameter allocation.
To apply an address pool on an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A