R0106-HP MSR Router Series MPLS Command Reference(V7)

113
Predefined user roles
network-admin
Parameters
ct0: Specifies CT 0 for the tunnel.
ct1: Specifies CT 1 for the tunnel.
ct2: Specifies CT 2 for the tunnel.
ct3: Specifies CT 3 for the tunnel.
bandwidth: Specifies the bandwidth required by the MPLS TE tunnel, in the range of 1 to 4294967295,
in kbps.
Usage guidelines
If you do not specify a CT for the tunnel, the tunnel is available for CT 0.
If the bandwidth required by the MPLS TE tunnel is more than 1024 kbps, HP recommends that you set
the bandwidth to a multiple of 1024 kbps.
This command applies only to the MPLS TE tunnels established by RSVP-TE. The bandwidth and CT of an
MPLS TE tunnel established by using a static CRLSP are determined by the static-cr-lsp ingress command.
Examples
# Assign 1000 kbps bandwidth to MPLS TE tunnel 0 and specify the CT of the tunnel as CT 1.
<Sysname> system-view
[Sysname] interface tunnel 0 mode mpls-te
[Sysname-Tunnel0] mpls te bandwidth ct1 1000
Related commands
• display mpls te tunnel-interface
• mpls te max-link-bandwidth
• mpls te max-reservable-bandwidth
• mpls te max-reservable-bandwidth mam
• mpls te max-reservable-bandwidth rdm
mpls te bandwidth change thresholds
Use mpls te bandwidth change thresholds to configure the bandwidth up/down threshold for the IGP to
flood TE information.
Use undo mpls te bandwidth change thresholds to restore the default.
Syntax
mpls te bandwidth change thresholds { down | up } percent
undo mpls te bandwidth change thresholds { down | up }
Default
The IGP floods the TE information when the bandwidth increases or decreases by 10% of the link
reservable bandwidth.
Views
Interface view