R0106-HP MSR Router Series MPLS Command Reference(V7)

321
[Sysname-tunnel-bundle2] description tunnel-bundle2
Related commands
display interface tunnel-bundle
destination
Use destination to specify the destination address for a tunnel bundle interface.
Use undo destination to restore the default.
Syntax
destination ip-address
undo destination
Default
No tunnel destination address is configured.
Views
Tunnel bundle interface view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the tunnel destination IPv4 address.
Usage guidelines
For MPLS L3VPN and MPLS L2VPN, the tunnel destination address in this command determines whether
the tunnel bundle can be the public tunnel to carry VPN services. When the remote PE address is the
same as the tunnel destination address for a tunnel bundle interface, the tunnel bundle can be the public
tunnel.
HP recommends configuring the same tunnel destination address for a tunnel bundle interface and its
member interfaces. If they have different tunnel destination addresses, make sure the member interfaces
have a route to the tunnel bundle interface. Otherwise, traffic forwarding will fail.
Examples
# Specify 2.2.2.2 as the destination address for Tunnel-Bundle 2.
<Sysname> system-view
[Sysname] interface tunnel-bundle 2
[Sysname-tunnel-bundle2] destination 2.2.2.2
Related commands
• display interface tunnel-bundle
• display tunnel-bundle
display interface tunnel-bundle
Use display interface tunnel-bundle to display tunnel bundle interface information.
Syntax
display interface [ tunnel-bundle [ number ] ] [ brief [ description | down ] ]