R0106-HP MSR Router Series MPLS Command Reference(V7)

338
Syntax
psc message-interval interval
undo psc message-interval
Default
The PSC message sending interval is 5 seconds.
Views
MPLS protection switching view
Predefined user roles
network-admin
Parameters
interval: Specifies the PSC message sending interval in the range of 1 to 65535 seconds.
Usage guidelines
The two ends of a tunnel periodically send PSC messages to coordinate the protection state for
bidirectional path switching.
You can prevent PSC messages from occupying too much bandwidth and resources by modifying the
sending interval as needed.
You can execute this command only after MPLS protection switching is enabled by using the mpls
protection command.
Examples
# Configure the PSC message sending interval to 10 seconds.
<Sysname> system-view
[Sysname] mpls protection
[sys-mpls-protection] psc message-interval 10
Related commands
• mpls protection
• protection switching-mode bidirectional
reset counters interface
Use reset counters interface to clear interface statistics.
Syntax
reset counters interface [ tunnel-bundle [ number ] ]
Views
User view
Predefined user roles
network-admin
Parameters
tunnel-bundle: Specifies a tunnel bundle interface.
number: Specifies the tunnel bundle interface number. The following matrix shows the value ranges for
the number argument: