R0106-HP MSR Router Series MPLS Command Reference(V7)

41
Instance Parameters:
Instance ID : 0 Instance State : Active
LSR ID : 0.0.0.0
Loop Detection : Off
Hop Count Limit : 32 Path Vector Limit : 32
Label Retention Mode: Liberal Label Distribution Control Mode: Ordered
IGP Sync Delay : 0 sec
Table 18 Command output
Field Descri
p
tion
Global Parameters Global parameters for all LDP-enabled networks.
Protocol Version LDP protocol version.
IGP Sync Delay on Restart
Maximum delay time (in seconds) that LDP must wait before it notifies
IGP of an LDP session-up event when there is an LDP restart.
Nonstop Routing
Whether the nonstop routing function is enabled.
• On—Enabled.
• Off—Disabled.
Graceful Restart
Whether the GR function is enabled.
• On—Enabled.
• Off—Disabled.
Reconnect Time Value of the Reconnect timer, in seconds.
Forwarding State Hold Time Value of the MPLS Forwarding State Holding timer, in seconds.
DSCP Value DSCP value for outgoing LDP packets.
Instance Parameters Running parameters for a specific VPN instance or public network.
Instance ID VPN instance ID. For the public network, this field displays 0.
Instance State LDP status in the VPN instance, Active or Inactive.
LSR ID LSR ID of the local device.
Loop Detection
Whether loop detection is enabled.
• On—Enabled.
• Off—Disabled.
Hop Count Limit Hop count limit specified for loop detection.
Path Vector Limit Path Vector length limit specified for loop detection.
Label Retention Mode The device supports only the Liberal mode.
IGP Sync Delay
Delay time (in seconds) that LDP must wait before it notifies IGP of an
LDP session-up event.
display mpls ldp peer
Use display mpls ldp peer to display the LDP peer and session information.
Syntax
MSR2000/MSR3000:
display mpls ldp peer [ vpn-instance vpn-instance-name ] [ peer-lsr-id ] [ verbose ]