R0106-HP MSR Router Series MPLS Command Reference(V7)

64
Using mpls ldp transport-address in interface view, you specify the transport address carried in the Link
Hellos sent out of the interface.
Using mpls ldp transport-address in LDP peer view, you specify the transport address carried in the
Targeted Hellos sent to the LDP peer.
HP recommends using the default transport address.
If two LSRs have multiple links in between and you want to establish an LDP session on each link, make
sure that all the links use the same transport address.
Examples
# Specify the LDP transport address carried in Targeted Hellos sent to peer 3.3.3.3 as 2.2.2.2.
<Sysname> System-view
[Sysname] mpls ldp
[Sysname-ldp] targeted-peer 3.3.3.3
[Sysname-ldp-peer-3.3.3.3] mpls ldp transport-address 2.2.2.2
# On interface GigabitEthernet 2/0/1, specify the LDP transport address carried in Link Hellos as the IP
address of the interface.
<Sysname> System-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] mpls ldp transport-address interface
Related commands
display mpls ldp discovery
non-stop-routing
Use non-stop-routing to enable LDP NSR.
Use undo non-stop-routing to disable LDP NSR.
Syntax
non-stop-routing
undo non-stop-routing
The following matrix shows the support of MSR routers for the command:
Hardware Command com
p
atibilit
y
MSR2000 No
MSR3000 No
MSR4000 Yes
Default
LDP NSR is disabled.
Views
LDP view
Predefined user roles
network-admin