R0106-HP MSR Router Series MPLS Command Reference(V7)

73
undo destination
Default
No destination address is specified for a tunnel bundle interface.
Views
Tunnel bundle interface view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the destination IPv4 address.
Usage guidelines
When the remote PE's address is the same as the destination address of a tunnel bundle interface, the
tunnel bundle can be used as the public tunnel for MPLS L3VPN and MPLS L2VPN to carry VPN services.
HP recommends configuring the same destination address for a tunnel bundle interface and its member
interfaces. Otherwise, traffic cannot be forwarded unless the tunnel bundle interface's destination
address can be reached through the member interfaces.
Examples
# Configure the destination address for tunnel bundle interface Tunnel-Bundle 2 as 2.2.2.2.
<Sysname> system-view
[Sysname] interface tunnel-bundle 2
[Sysname-tunnel-bundle2] destination 2.2.2.2
Related commands
display tunnel-bundle
disable
Use disable to disable the current explicit path.
Use undo disable to restore the default.
Syntax
disable
undo disable
Default
The explicit path is enabled.
Views
Explicit path view
Predefined user roles
network-admin
Usage guidelines
You can use the disable command to prevent an explicit path from being used by a tunnel during explicit
path configuration.