R0106-HP MSR Router Series MPLS Configuration Guide(V7)

215
Ste
p
Command Remarks
7. Redistribute the VPN
routes of the VPN site.
import-route protocol [ process-id |
all-processes ] [ allow-direct | med
med-value | route-policy
route-policy-name ] *
By default, no routes are
redistributed into BGP.
8. (Optional.) Configure
filtering of advertised
routes.
filter-policy { acl-number | prefix-list
prefix-list-name } export [ protocol
process-id ]
By default, BGP does not filter
advertised routes.
9. (Optional.) Configure
filtering of received routes.
filter-policy { acl-number | prefix-list
prefix-list-name } import
Optional.
By default, BGP does not filter
received routes.
Configuring IBGP between an MCE and a PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter BGP-VPN instance view.
ip vpn-instance vpn-instance-name N/A
4. Configure the PE as an IBGP
peer.
peer { group-name | ip-address }
as-number as-number
N/A
5. Enter BGP-VPN IPv4 unicast
address family view.
address-family ipv4 [ unicast ] N/A
6. Enable BGP to exchange IPv4
unicast routes with the peer.
peer { group-name | ip-address }
enable
By default, BGP does not
exchange IPv4 unicast routes
with any peer.
7. Redistribute the VPN routes of
the VPN site.
import-route protocol [ process-id |
all-processes ] [ allow-direct | med
med-value | route-policy
route-policy-name ] *
By default, no routes are
redistributed into BGP.
8. (Optional.) Configure filtering
of advertised routes.
filter-policy { acl-number | prefix-list
prefix-list-name } export [ protocol
process-id ]
By default, BGP does not filter
advertised routes.
9. (Optional.) Configure filtering
of received routes.
filter-policy { acl-number | prefix-list
prefix-list-name } import
Optional.
By default, BGP does not filter
received routes.
Specifying the VPN label processing mode on the
egress PE
An egress PE can process VPN labels in either POPGO or POP mode:
• POPGO forwarding—Pops the label and forwards the packet out of the egress interface
corresponding to the label.
• POP forwarding—Pops the label and forwards the packet through the FIB table.
To specify the VPN label processing mode on an egress PE: