R0106-HP MSR Router Series MPLS Configuration Guide(V7)

311
Ste
p
Command Remarks
9. (Optional.) Configure
filtering of received routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
import
By default, the PE does not filter
received routes.
2. Configure the CE:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Configure the PE as an EBGP
peer.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
configured.
4. Create the BGP IPv6 unicast
address family and enter its
view.
address-family ipv6 [ unicast ]
By default, the BGP IPv6 unicast
address family is not created.
5. Enable IPv6 unicast route
exchange with the specified
peer or peer group.
peer { group-name | ip-address }
enable
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
6. (Optional.) Configure route
redistribution.
import-route protocol
[ { process-id | all-processes }
[ allow-direct | med med-value |
route-policy route-policy-name ]
* ]
A CE must advertise its VPN
routes to the connected PE so that
the PE can advertise them to the
peer CE.
Configuring IBGP between a PE and a CE
Use IBGP between PE and CE only in a basic IPv6 MPLS L3VPN network. In networks such as inter-AS
VPN and carrier's carrier, you cannot configure IBGP between PE and CE.
1. Configure the PE:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter BGP-VPN instance
view.
ip vpn-instance
vpn-instance-name
Configuration commands in
BGP-VPN instance view are the
same as those in BGP view. For
more information, see Layer
3—IP Routing Configuration
Guide.
4. Configure the CE as the VPN
IBGP peer.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
created.
5. Create the BGP-VPN IPv6
unicast family and enter its
view.
address-family ipv6 [ unicast ]
By default, the BGP-VPN IPv6
unicast family is not created.