R0106-HP MSR Router Series MPLS Configuration Guide(V7)

313
Configuring routing between PEs
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Configure the remote PE as the
peer.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
configured.
4. Specify the source interface for
route update packets sent to
the specified peer.
peer { group-name | ip-address }
connect-interface interface-type
interface-number
By default, BGP uses the outbound
interface of the best route to the
BGP peer as the source interface.
5. Create the BGP VPNv6
address family and enter its
view.
address-family vpnv6
By default, the BGP VPNv6
address family is not created.
6. Enable BGP VPNv6 route
exchange with the specified
peer.
peer { group-name | ip-address }
enable
By default, BGP does not exchange
BGP VPNv6 routes with any peer.
Configuring BGP VPNv6 route control
BGP VPNv6 route control is configured similarly with BGP route control, except that it is configured in
BGP VPNv6 address family view. For detailed information about BGP route control, see Layer 3—IP
Routing Configuration Guide.
To configure BGP VPNv6 route control:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter BGP VPNv6 address
family view.
address-family vpnv6 N/A
4. (Optional.) Configure filtering
of advertised routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
export [ protocol process-id ]
By default, the PE does not filter
advertised routes.
5. (Optional.) Configure filtering
of received routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
import
By default, the PE does not filter
received routes.
6. Configure ACL-based route
filtering for the specified peer
or peer group.
peer { group-name | ip-address }
filter-policy acl6-number { export |
import }
By default, no ACL-based route
filtering is configured.
7. Configure IPv6 prefix list-based
route filtering for the specified
peer or peer group.
peer { group-name | ip-address }
prefix-list ipv6-prefix-name
{ export | import }
By default, no IPv6 prefix list-based
route filtering is configured.
8. Specify a preferred value for
routes received from the peer
or peer group.
peer { group-name | ip-address }
preferred-value value
The default preferred value is 0.