R0106-HP MSR Router Series MPLS Configuration Guide(V7)

317
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure an IPv6 static
route for an IPv6 VPN
instance.
ipv6 route-static vpn-instance s-vpn-instance-name
ipv6-address prefix-length { interface-type
interface-number [ next-hop-address ] |
nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address } [ permanent ]
[ preference preference-value ] [ tag tag-value ]
[ description description-text ]
By default, no static
route is configured.
Perform this
configuration on the
MCE. On a VPN site,
configure normal IPv6
static routes.
3. (Optional.) Configure the
default preference for
IPv6 static routes.
ipv6 route-static default-preference
default-preference-value
The default preference
for IPv6 static routes is
60.
Configuring RIPng between an MCE and a VPN site
A RIPng process belongs to the public network or a single IPv6 VPN instance. If you create a RIPng
process without binding it to an IPv6 VPN instance, the process belongs to the public network. By
configuring RIPng process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different VPNs
to be exchanged between the MCE and the sites through different RIPng processes, ensuring the
separation and security of IPv6 VPN routes.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
To configure RIPng between an MCE and a VPN site:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a RIPng process for a
VPN instance and enter RIPng
view.
ripng [ process-id ] vpn-instance
vpn-instance-name
Perform this configuration on the
MCE. On a VPN site, configure
normal RIPng.
3. Redistribute remote site routes
advertised by the PE.
import-route protocol [ process-id ]
[ allow-ibgp ] [ allow-direct | cost
cost | route-policy
route-policy-name ] *
By default, no routes are
redistributed into RIPng.
4. (Optional.) Configure the
default cost value for the
redistributed routes.
default cost value The default value is 0.
5. Return to system view.
quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable RIPng on the interface.
ripng process-id enable RIPng is disabled by default.
Configuring OSPFv3 between an MCE and a VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public network.