R0106-HP MSR Router Series MPLS Configuration Guide(V7)
318
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different
IPv6 VPNs to be exchanged between the MCE and the sites through different OSPFv3 processes,
ensuring the separation and security of IPv6 VPN routes.
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
To configure OSPFv3 between an MCE and a VPN site:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Create an OSPFv3 process for
a VPN instance and enter
OSPFv3 view.
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
Perform this configuration on the
MCE. On a VPN site, configure
common OSPFv3.
The maximum number of OSPFv3
processes for a VPN instance
depends on the device memory.
Deleting a VPN instance also
deletes all related OSPFv3
processes.
3. Set the router ID.
router-id router-id N/A
4. Redistribute remote site routes
advertised by the PE.
import-route protocol [ process-id
| all-processes | allow-ibgp ]
[ allow-direct | cost cost |
route-policy route-policy-name |
type type ] *
By default, no routes are
redistributed into OSPFv3.
5. Return to system view.
quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable OSPFv3 on the
interface.
ospfv3 process-id area area-id
[ instance instance-id ]
By default, OSPFv3 is disabled on
an interface.
Configuring IPv6 IS-IS between an MCE and a VPN site
An IPv6 IS-IS process belongs to the public network or a single IPv6 VPN instance. If you create an IPv6
IS-IS process without binding it to an IPv6 VPN instance, the process belongs to the public network.
By configuring IPv6 IS-IS process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different
IPv6 VPNs to be exchanged between the MCE and the sites through different IPv6 IS-IS processes. This
ensures the separation and security of IPv6 VPN routes. For more information about IPv6 IS-IS, see Layer
3—IP Routing Configuration Guide.
To configure IPv6 IS-IS between an MCE and a VPN site:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Create an IPv6 IS-IS process for
a VPN instance and enter IS-IS
view.
isis [ process-id ] vpn-instance
vpn-instance-name
Perform this configuration on the
MCE. On a VPN site, configure
common IPv6 IS-IS.
3. Configure a network entity title
for the IS-IS process.
network-entity net By default, no NET is configured.