R0106-HP MSR Router Series MPLS Configuration Guide(V7)

319
Ste
p
Command Remarks
4. Enable IPv6 for the IPv6 IS-IS
process.
ipv6 enable By default, IPv6 is disabled.
5. (Optional.) Redistribute remote
site routes advertised by the PE.
ipv6 import-route protocol
[ process-id ] [ allow-ibgp ]
[ allow-direct | cost cost | [ level-1
| level-1-2 | level-2 ] |
route-policy route-policy-name |
tag tag ] *
By default, no routes are
redistributed to IPv6 IS-IS.
If you do not specify the route level
in the command, redistributed
routes are added to the level-2
routing table.
6. Return to system view.
quit N/A
7. Enter interface view.
interface interface-type
interface-number
N/A
8. Enable the IPv6 IS-IS process
on the interface.
isis ipv6 enable [ process-id ]
By default, no IPv6 IS-IS process is
enabled.
Configuring EBGP between an MCE and a VPN site
To use EBGP between an MCE and IPv6 VPN sites, you must configure a BGP peer for each IPv6 VPN
instance on the MCE, and redistribute the IGP routes of each VPN instance on the IPv6 VPN sites. You
can also configure the filtering of received and advertised routes.
1. Configure the MCE:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter BGP-VPN instance
view.
ip vpn-instance
vpn-instance-name
N/A
4. Specify an IPv6 BGP peer in
an AS.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
configured.
5. Enter BGP-VPN IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A
6. Enable BGP to exchange
IPv6 unicast routes with the
specified peer.
peer { group-name | ip-address }
enable
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
7. Redistribute remote site
routes advertised by the PE.
import-route protocol
[ { process-id | all-processes }
[ allow-direct | med med-value |
route-policy route-policy-name ]
* ]
By default, no route redistribution
is configured.
8. (Optional.) Configure
filtering of advertised routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
export [ protocol process-id ]
By default, BGP does not filter
advertised routes.
9. (Optional.) Configure
filtering of received routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
import
By default, BGP does not filter
received routes.
2. Configure a VPN site: