R0106-HP MSR Router Series MPLS Configuration Guide(V7)

383
Ste
p
Command Remarks
3. (Optional.) Configure a
description for the
cross-connect group.
description text
By default, no description is
configured for the cross-connect
group.
4. (Optional.) Enable the
cross-connect group.
undo shutdown
By default, the cross-connect group
is enabled.
5. Create a cross-connect and
enter cross-connect view.
connection connection-name
By default, no cross-connect is
created.
6. Configure an MTU for the PW.
mtu mtu
The default MTU is 1500 bytes.
The two PEs on an LDP PW must
have the same MTU configured for
the PW. Otherwise, the PW cannot
go up.
Configuring a PW
Configuring a PW class
You can configure PW attributes such as the PW type and enable control word in a PW class. PWs with
the same attributes can reference the same PW class.
To configure a PW class:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a PW class and enter
PW class view.
pw-class class-name By default, no PW class is created.
3. (Optional.) Enable control
word.
control-word enable
By default, control word is
disabled.
4. (Optional.) Specify the PW
type.
pw-type { ethernet | vlan } By default, the PW type is VLAN.
Configuring a static PW
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter cross-connect group
view.
xconnect-group group-name N/A
3. Enter cross-connect view.
connection connection-name N/A
4. Configure a static PW and
enter cross-connect PW view.
peer ip-address pw-id pw-id
in-label label-value out-label
label-value [ pw-class class-name |
tunnel-policy tunnel-policy-name ] *
By default, no static PW is
configured.