Manualshelf

R0106-HP MSR Router Series MPLS Configuration Guide(V7)

ManualsBrandsHP ManualsNetwork HardwareHP MSR3024 TAA-compliant AC Router
391392393394395396397398399400
386
Ste
p
Command
Remarks
5. Configure route targets for the
cross-connect group.
vpn-target vpn-target&<1-8> [ both
| export-extcommunity |
import-extcommunity ]
By default, no route targets are
configured for the cross-connect
group.
6. (Optional.) Reference a PW
class.
pw-class class-name
By default, no PW class is
referenced.
7. (Optional.) Configure an MTU
for the PW.
mtu mtu The default MTU is 1500 bytes.
8. Create a local site and enter
site view.
site site-id [ range range-value ]
[ default-offset default-offset ]
By default, no local site is created.
9. Create a cross-connect and
enter auto-discovery
cross-connect view.
connection remote-site-id
remote-site-id
By default, no cross-connect is
created.
After you execute this command, a
PW to the specified remote site is
created and is bound to the
cross-connect.
10. (Optional.) Reference a tunnel
policy.
tunnel-policy tunnel-policy-name
By default, no tunnel policy is
referenced.
Configuring a remote CCC connection
To configure a remote CCC connection, perform the following configurations on the PE and P devices:
• On the two PEs, use the ccc command to specify the incoming and outgoing labels.
• On each P device between the two PEs, use the static-lsp transit command to configure a static LSP
for each direction of the CCC connection. For more information about the static-lsp transit
command, see MPLS Command Reference.
Follow these guidelines when you configure a remote CCC connection:
• The outgoing label specified on a device must be the same as the incoming label specified on the
next-hop device.
• CCC connection settings such as the encapsulation type and control word function must be
consistent on the two PEs. Otherwise, the PEs might fail to forward packets over the CCC
connection.
To configure a remote CCC connection:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter cross-connect
group view.
xconnect-group group-name N/A
3. Enter cross-connect
view.
connection connection-name N/A