R0106-HP MSR Router Series MPLS Configuration Guide(V7)

397
Verifying the configuration
# Display L2VPN PW information on PE 1. The output shows that a static PW has been established.
[PE1] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpna
Peer PW ID In/Out Label Proto Flag Link ID State
192.3.3.3 3 100/200 Static M 0 Up
# Display L2VPN PW information on PE 2. The output shows that a static PW has been established.
[PE2] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpna
Peer PW ID In/Out Label Proto Flag Link ID State
192.2.2.2 3 200/100 Static M 0 Up
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)
Configuring an LDP PW
Network requirements
Create an LDP PW between PE 1 and PE 2 over the backbone so CE 1 and CE 2 can communicate with
each other.
Figure 100 Network diagram
Table 36 Interface and IP address assignment
Device Interface IP address
Device Interface IP address
CE 1 GE2/1/1 100.1.1.1/24 P Loop0 192.4.4.4/32
PE 1 Loop0 192.2.2.2/32 GE2/1/1 10.1.1.2/24
GE2/1/1 - GE2/1/2 10.2.2.2/24
GE2/1/2 10.1.1.1/24 PE 2 Loop0 192.3.3.3/32