R0106-HP MSR Router Series MPLS Configuration Guide(V7)

Figure 17 Network diagram

Requirements analysis

• To ensure that the LSRs establish LSPs automatically, enable LDP on each LSR.

• To establish LDP LSPs, configure a routing protocol to ensure IP connectivity between the LSRs. This

example uses OSPF.

• To control the number of LSPs, configure an LSP generation policy on each LSR.

Configuration procedure

1. Configure IP addresses and masks for interfaces, including the loopback interfaces, as shown

in Figure 17. (Details not sh

own.)

2. Configure OSPF on each router to ensure IP connectivity between them:

# Configure Router A.

<RouterA> system-view

[RouterA] ospf

[RouterA-ospf-1] area 0

[RouterA-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0

[RouterA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255

[RouterA-ospf-1-area-0.0.0.0] network 11.1.1.0 0.0.0.255

[RouterA-ospf-1-area-0.0.0.0] quit

[RouterA-ospf-1] quit

# Configure Router B.

<RouterB> system-view

[RouterB] ospf

[RouterB-ospf-1] area 0

[RouterB-ospf-1-area-0.0.0.0] network 2.2.2.9 0.0.0.0

[RouterB-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255

[RouterB-ospf-1-area-0.0.0.0] network 20.1.1.0 0.0.0.255

[RouterB-ospf-1-area-0.0.0.0] quit

[RouterB-ospf-1] quit

# Configure Router C.

<RouterC> system-view

[RouterC] ospf

[RouterC-ospf-1] area 0

[RouterC-ospf-1-area-0.0.0.0] network 3.3.3.9 0.0.0.0

[RouterC-ospf-1-area-0.0.0.0] network 20.1.1.0 0.0.0.255

[RouterC-ospf-1-area-0.0.0.0] network 21.1.1.0 0.0.0.255