R0106-HP MSR Router Series MPLS Configuration Guide(V7)

10. On the ingress node of the MPLS TE tunnel, configure RSVP-TE to establish a CRLSP based on the

tunnel constraints and link TE attributes.

11. On the ingress node of the MPLS TE tunnel, configure static routing, PBR, or automatic route

advertisement to direct traffic to the MPLS TE tunnel.

You can also configure other MPLS TE functions such as the DS-TE, automatic bandwidth adjustment, and

FRR as needed.

To configure MPLS TE, perform the following tasks:

Tasks at a

lance

(Required.) Enabling MPLS TE

(Required.) Configuring a tunnel interface

(Optional.) Configuring DS-TE

(Required.) Perform at least one of the following tasks to configure an MPLS TE tunnel:

• Configuring an MPLS TE tunnel to use a static CRLSP

• Configuring an MPLS TE tunnel to use a dynamic CRLSP

(Optional.) Configuring load sharing for an MPLS TE tunnel

(Required.) Configuring traffic forwarding:

• Configuring static routing to direct traffic to an MPLS TE tunnel or tunnel bundle

• Configuring PBR to direct traffic to an MPLS TE tunnel or tunnel bundle

• Configuring automatic route advertisement to direct traffic to an MPLS TE tunnel or tunnel bundle

(Optional.) Configuring a bidirectional MPLS TE tunnel

(Optional.) Configuring CRLSP backup

Only MPLS TE tunnels established by RSVP-TE support this configuration.

(Optional.) Configuring MPLS TE FRR

Only MPLS TE tunnels established by RSVP-TE support this configuration.

(Optional.) Enabling SNMP notifications for MPLS TE

Enabling MPLS TE

Enable MPLS TE on each node and interface that the MPLS TE tunnel traverses.

Before you enable MPLS TE, complete the following tasks:

• Configure static routing or IGP to make sure all LSRs can reach each other.

• Enable MPLS. For information about enabling MPLS, see "Configuring basic MPLS."

To enable MPLS TE:

Ste

Command

Remarks

1. Enter system view.

system-view N/A