R0106-HP MSR Router Series MPLS Configuration Guide(V7)

76
Ste
p
Command Remarks
7. (Optional.) Reset the
automatic bandwidth
adjustment.
reset mpls te
auto-bandwidth-adjustment timers
After this command is executed, the
system clears the output rate
sampling information and the
remaining time to the next
bandwidth adjustment to start a new
output rate sampling and bandwidth
adjustment.
Configuring RSVP resource reservation style
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel
interface view.
interface tunnel tunnel-number
[ mode mpls-te ]
N/A
3. Configure the resources
reservation style for the
tunnel.
mpls te resv-style { ff | se }
By default, the resource reservation
style is SE.
In current MPLS TE applications,
tunnels are established usually by
using the make-before-break
mechanism. Therefore, HP
recommends that you use the SE style.
Configuring load sharing for an MPLS TE tunnel
MPLS TE tunnel load sharing specifies multiple member interfaces (MPLS TE tunnel interfaces) for a tunnel
bundle interface in load sharing mode. The member interfaces form a tunnel bundle. When the outgoing
interface is the tunnel bundle interface, traffic can be forwarded through multiple MPLS TE tunnels, and
load sharing is implemented.
Perform this task on the ingress node of the MPLS TE tunnel.
To configure load sharing for an MPLS TE tunnel:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a tunnel bundle
interface in load sharing
mode, and enter tunnel bundle
interface view.
interface tunnel-bundle number
By default, no tunnel bundle
interface is configured.
3. Configure an IP address for the
tunnel bundle interface.
ip address ip-address { mask-length
| mask }
By default, no IP address is
configured for a tunnel bundle
interface.