R0106-HP MSR Router Series Network Management and Monitoring Command Reference(V7)

123
Default
No PoE profile is applied to a PI.
Views
System view
Predefined user roles
network-admin
Parameters
index index: Specifies a PoE profile by its index number in the range of 1 to 100.
name profile-name: Specifies a PoE profile by its name, a case-sensitive string of 1 to 15 characters.
interface-range: Specifies a range of Ethernet interfaces in the form of interface-type interface-number
[ to interface-type interface-number ], where interface-type interface-number represents the interface type
and interface number. The start interface number must be smaller than the end interface number. If an
interface in the specified range does not support PoE, it is ignored when the PoE profile is applied.
Examples
# Apply the PoE profile named forIPphone to GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] apply poe-profile name forIPphone interface gigabitethernet 2/1/1
# Apply the PoE profile with index number 1 to GigabitEthernet 2/1/2 to GigabitEthernet 2/1/8.
<Sysname> system-view
[Sysname] apply poe-profile index 1 interface gigabitethernet 2/1/2 to gigabitethernet
2/1/8
Related commands
• apply poe-profile
• display poe-profile interface
display poe device
Use display poe device to display brief PSE information, including the ID, slot number, and status of PSEs.
Syntax
display poe device
Views
Any view
Predefined user roles
network-admin
network-operator
Examples
# Display PSE information.
<Sysname> display poe device
PSE ID Slot No. SSlot No. PortNum MaxPower(W) State Model
1 0 0 48 0 Off DSIC-9FSWP