R0106-HP MSR Router Series Network Management and Monitoring Command Reference(V7)

125
Electric Current : 244 mA
Voltage : 51.7 V
PD Description : IP Phone For Room 101
Table 22 Command output
Field Description
PoE status
PoE status:
• Enabled.
• Disabled.
Power Priority
Power supply priority of the PI:
• Critical (highest).
• High.
• Low.
Oper
Operating status of a PI:
• Off—PoE is disabled.
• On—Power is being supplied to a PI correctly.
• Power-lack—Remaining guaranteed power for a critical PI is
insufficient.
• Power-deny—The PSE refuses to supply power. The power required
by the PD is higher than the configured power.
• Power-itself—The PD is using another power supply.
• Power-limit—The PSE is supplying a limited power. The PD requires
more power than the configured power, but the PSE supplies power to
the PD based on the configured power.
IEEE Class
PD power class: 0, 1, 2, 3, or 4.
If PoE is not supported, this field displays a hyphen (-).
Detection Status
Power detection status of a PI:
• Disabled—The PoE function is disabled.
• Searching—The PI is searching for the PD.
• Delivering power—The PI is supplying power to the PD.
• Fault—A fault has occurred during the test.
• Test—The PI is undergoing a test.
• Other fault—A fault has caused the PSE to enter the idle status.
• PD disconnected—The PD is disconnected.
Power Mode
Power mode of a PI:
• Signal—Power is being supplied over signal cables.
• Spare—Power is being supplied over spare cables.
Current Power
Current power of a PI, including PD consumption power and transmission
loss.
Transmission loss usually does not exceed 1 watt.
Average Power Average power of a PI.
Peak Power Peak power of a PI.
Max Power Maximum power of a PI.
Electric Current Current of a PI.