R0106-HP MSR Router Series Network Management and Monitoring Command Reference(V7)

164
Engine ID: 800063A203000FE240A1A6
Storage-type: nonVolatile
UserStatus: active
Username: userv3code
Group name: groupv3code
Engine ID: 800063A203000FE240A1A6
Storage-type: nonVolatile
UserStatus: active
Table 41 Command output
Field Descri
p
tion
Username SNMP username.
Group name SNMP group name.
Engine ID Engine ID that the SNMP agent used when the SNMP user was created.
Storage-type
Storage type:
• volatile.
• nonvolatile.
• permanent.
• readOnly.
• other.
For more information about these storage types, see Table 31.
UserStatus
SNMP user status:
• active—The SNMP user is effective.
• notInService—The SNMP user is correctly configured but not activated.
• notReady—The SNMP user configuration is incomplete.
• other—Any other status.
SNMP users are active upon their creation at the CLI. To temporarily disable an
SNMP user without deleting it, you can perform an SNMP set operation to change
its status.
ACL
Number of the ACL that controls the access of the SNMP user (the NMS) to the
device.
To access the device, the IP address of the NMS must be permitted in the ACL.
This field appears only when an SNMPv3 user is associated with an ACL rule.
Related commands
snmp-agent usm-user v3
enable snmp trap updown
Use enable snmp trap updown to enable link state notifications on an interface.
Use undo enable snmp trap updown to disable link state notifications on an interface.
Syntax
enable snmp trap updown