R0106-HP MSR Router Series Network Management and Monitoring Command Reference(V7)

232
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 reboot
action switchover
Use action switchover to add an active/standby switchover action to a monitor policy.
Use undo action to remove an action.
Syntax
action number switchover
undo action number
The following matrix shows the support of MSR routers for the command:
Hardware Command com
p
atibilit
y
MSR2000 No
MSR3000 No
MSR4000 Yes
Default
Monitor policies do not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
Usage guidelines
You can configure a series of actions to be executed in response to the event specified in a monitor policy.
EAA executes the actions in ascending order of action IDs. You must make sure the execution order is
correct when you add actions to a policy.
Examples
# Configure an action for the CLI-defined policy test to perform an active/standby switchover.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 switchover
action syslog
Use action syslog to add a Syslog action to a monitor policy.
Use undo action to remove an action.