R0106-HP MSR Router Series Network Management and Monitoring Command Reference(V7)

322
Views
System view, NetStream aggregation mode view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies a source interface by its type and number.
Usage guidelines
You can configure different source interfaces in different NetStream aggregation mode views.
If no source interface is configured in NetStream aggregation mode view, the source interface in system
view applies.
Examples
# Specify GigabitEthernet 2/1/1 as the source interface for NetStream data packets.
<Sysname> system-view
[Sysname] ip netstream export source interface gigabitethernet 2/1/1
Related commands
ip netstream aggregation
ip netstream export v9-template refresh-rate packet
Use ip netstream export v9-template refresh-rate packet to configure the refresh frequency (in packets)
for NetStream version 9 templates. The templates are sent after the specified number of packets are sent.
Use undo ip netstream export v9-template refresh-rate packet to restore the default.
Syntax
ip netstream export v9-template refresh-rate packet packets
undo ip netstream export v9-template refresh-rate packet
Default
Version 9 templates are sent every 20 packets.
Views
System view
Predefined user roles
network-admin
Parameters
packets: Specifies the number of packets that are sent before a version 9 template is sent to NetStream
servers for an update. The value range is 1 to 600.
Usage guidelines
Version 9 is template-based and supports user-defined formats. A NetStream-enabled device must
periodically resend the updated template to NetStream servers, because the servers do not save the
template permanently. The server cannot associate the statistics with their proper fields when the
following conditions exist:
• The version 9 template is changed on the NetStream-enabled device.