R0106-HP MSR Router Series Network Management and Monitoring Command Reference(V7)

343
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance to which the destination host
belongs. The vpn-instance-name argument is a case-sensitive string of 1 to 31 characters. If the
destination is on the public network, do not specify this option.
Usage guidelines
You cannot use the display ipv6 netstream export command to display information about the IPv6
NetStream aggregation mode that is not enabled.
You can specify the same destination host in different IPv6 NetStream aggregation mode views.
The destination hosts in an IPv6 NetStream aggregation mode view take precedence over those in system
view. If no destination host is specified in an IPv6 NetStream aggregation mode view, the destination
host in system view applies.
You can specify a maximum of four destination hosts in system view or in IPv6 NetStream aggregation
mode view. If you specify a destination host with the same IPv4 addresses but different UDP ports, the
most recent configuration takes effect. You can specify destination hosts with the same IPv4 address and
UDP port but different VPN instances.
You can specify a maximum of four destination hosts in system view or in IPv6 NetStream aggregation
mode view. If you specify a destination host with the same IPv6 addresses but different UDP ports, the
most recent configuration takes effect. You can specify destination hosts with the same IPv6 address and
UDP port but different VPN instances.
IPv6 NetStream traditional data are exported to all destination hosts in system view. IPv6 NetStream
aggregation data are exported to all destination hosts in the related aggregation view. If you expect IPv6
NetStream aggregation data only, you can specify destination hosts in only the IPv6 NetStream
aggregation mode view. This setting reduces bandwidth occupation.
Examples
# Specify the destination host for IPv6 NetStream data export as 1.1.1.1 and UDP port 5000.
<Sysname> system-view
[Sysname] ipv6 netstream export host 1.1.1.1 5000
Related commands
• ipv6 netstream aggregation
• ipv6 netstream export source
ipv6 netstream export rate
Use ipv6 netstream export rate to limit the IPv6 NetStream data export rate.
Use undo ipv6 netstream export rate to restore the default.
Syntax
ipv6 netstream export rate rate
undo ipv6 netstream export rate
Default
The export rate of IPv6 NetStream data is not limited.
Views
System view