R0106-HP MSR Router Series Network Management and Monitoring Command Reference(V7)

387
<Sysname> security-logfile save
The contents in the security log file buffer have been saved to the file
caf0:/seclog/seclog.log.
Related commands
• info-center security-logfile directory
• authorization-attribute (Security Command Reference)
terminal debugging
Use terminal debugging to enable the display of debug information on the current terminal.
Use undo terminal debugging to disable the display of debug information on the current terminal.
Syntax
terminal debugging
undo terminal debugging
Default
The display of debug information is disabled on the current terminal.
Views
User view
Predefined user roles
network-admin
Usage guidelines
To enable the display of debug information on the console, perform the following tasks:
1. Execute the terminal debugging command.
2. Enable the information center (enabled by default).
3. Use a debugging command to enable the related debugging.
To enable the display of debug information on the current terminal, perform the following tasks:
4. Execute the terminal monitor and terminal debugging commands.
5. Enable the information center (enabled by default).
6. Use a debugging command to enable the related debugging.
The configuration of this command is only valid for the current connection between the terminal and the
device. If a new connection is established, the default is restored.
You can also enable the display of debug information on the current terminal by executing the terminal
logging level 7 command. This command has the following differences from the terminal debugging
command:
• The terminal logging level 7 command enables log display for all levels (levels 0 through 7) on the
current terminal.
• The terminal debugging command only enables log display for the debug level (level 7) and the
levels that are higher than or equal to the severity level specified with the terminal logging level
command.
Examples
# Enable the display of debug information on the current terminal.