R0106-HP MSR Router Series Network Management and Monitoring Command Reference(V7)

67
ICMP/UDP echo operation view
UDP jitter operation view
Predefined user roles
network-admin
Usage guidelines
When the routing table bypass function is enabled, the routing table is not searched. Packets are sent
directly to the destination in a directly connected network.
Examples
# Enable the routing table bypass function.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route
source interface
Use source interface to specify the IP address of the specified interface as the source IP address for probe
packets.
Use undo source interface to restore the default.
Syntax
source interface interface-type interface-number
undo source interface
Default
No source IP address is specified for probe packets. The probe packets take the primary IP address of the
outgoing interface as their source IP address.
Views
ICMP echo operation view, DHCP operation view, ICMP template view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
If you configure both the source interface and source ip commands, the most recent configuration takes
effect.
The specified source interface must be up. Otherwise, no probe packets can be sent out.
Examples
# Specify the IP address of interface GigabitEthernet 2/1/1 as the source IP address of ICMP echo
request packets.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo