R0106-HP MSR Router Series Voice Command Reference(V7)

34
For the E&M non-signaling mode to work with the PLAR function, you must configure the private-line
command on the originating device. For more information about the PLAR function, see "Configuring dial
programs."
Examples
# Enable the E&M non-signaling mode for E&M interface 2/3/1 on the originating device, and specify
the monitoring time as 120 seconds.
<Sysname> system-view
[Sysname] subscriber-line 2/3/1
[Sysname-subscriber-line2/3/1] open-trunk caller monitor 120
Related commands
• private-line
• signal
passthrough
Use passthrough to enable E&M control signals pass-through.
Use undo passthrough to disable E&M control signals pass-through.
Syntax
passthrough
undo passthrough
Default
E&M analog control signals pass-through is disabled.
Views
E&M interface view
Default command level
network-admin
Usage guidelines
Configure this command on both the originating and terminating devices.
Examples
# Enable E&M analog control signals pass-through on E&M interface 2/3/1.
<Sysname> system-view
[Sysname] subscriber-line 2/3/1
[Sysname-subscriber-line2/3/1] passthrough
plc-mode
Use plc-mode to configure a packet loss compensation mode for an FXS or FXO interface.
Use undo plc-mode to restore the default.
Syntax
plc-mode { general | specific }
undo plc-mode