R0106-HP MSR Router Series Voice Command Reference(V7)

37
Default
The frequency for ring detection is 40 Hz.
Views
FXO interface view
Predefined user roles
network-admin
Parameters
value: Specifies the frequency value for ring detection, in Hz. The value is in the range of 30 to 100 in
increments of 10.
Usage guidelines
This command is supported only on routers installed with the interface module SIC-2FXS1FXO,
HMIM-8FXS8FXO, or DSIC-4FXS1FXO.
Examples
# Set the frequency value for ring detection on FXO interface 2/2/1 to 100 Hz.
<sysname> system-view
[sysname] subscriber-line 2/2/1
[sysname-subscriber-line2/2/1] ring-detect frequency 100
send-busytone enable
Use send-busytone enable to enable busy tone sending on an FXO interface.
Use undo send-busytone enable to disable busy tone sending.
Syntax
send-busytone enable
undo send-busytone enable
Default
Busy tone sending is disabled.
Views
FXO interface view
Predefined user roles
network-admin
Usage guidelines
If the PBX does not send busy tones, you can configure an FXO interface to send busy tones.
Examples
# Enable FXO interface 2/2/1 to send busy tones.
<Sysname> system-view
[Sysname] subscriber-line 2/2/1
[Sysname-subscriber-line2/2/1] send-busytone enable
Related commands
send-busytone time