R0106-HP MSR Router Series Voice Command Reference(V7)

42
Usage guidelines
This timer restarts each time the subscriber dials a digit. If the timer expires before the subscriber dials the
next digit, the system prompts the subscriber that the dialing times out.
The maximum interval from off-hook to dialing the first digit is set by the timer first-dial command.
Examples
# Configure the maximum interval for dialing the next digit to 5 seconds on FXS interface 2/1/1.
<Sysname> system-view
[Sysname] subscriber-line 2/1/1
[Sysname-subscriber-line2/1/1] timer dial-interval 5
timer disconnect-pulse
Use timer disconnect-pulse to configure the LCFO signal duration.
Use undo timer disconnect-pulse to restore the default.
Syntax
timer disconnect-pulse value
undo timer disconnect-pulse
Default
The LCFO signal duration is 750 milliseconds.
Views
FXS interface view
Predefined user roles
network-admin
Parameters
value: Specifies the LCFO signal duration in the range of 1 to 300 seconds in increments of 30.
Examples
# Configure the LCFO signal duration as 90 milliseconds on FXS interface 2/1/1.
<Sysname> system-view
[Sysname] subscriber-line 2/1/1
[Sysname-subscriber-line2/1/1] timer disconnect-pulse 90
Related commands
disconnect lcfo
timer first-dial
Use timer first-dial to configure the timeout time between off-hook and dialing the first digit.
Use undo timer first-dial to restore the default.
Syntax
timer first-dial seconds
undo timer first-dial