R0106-HP MSR Router Series Voice Command Reference(V7)

48
ani-digit
Use ani-digit to set the number of dialed digits that the terminating side collects before requesting calling
information.
Use undo ani-digit to restore the default.
Syntax
ani-offset number
undo ani-offset
Default
The number of dialed digits that the terminating side collects before requesting calling information is 1.
Views
R2 CAS view
Predefined user roles
network-admin
Parameters
number: Specifies the number of dialed digits, in the range of 1 to 10.
Usage guidelines
When the number of collected digits is smaller than the specified number, the terminating side waits for
the next digit until the timer expires. When the number of collected digits equals or exceeds the specified
number, the terminating side requests the calling information.
This command takes effect only after you configure the ani all command.
Examples
# Set the number of collected digits to 3.
<Sysname> system-view
[Sysname] controller e1 2/4/1
[Sysname-E1 2/4/1] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-E1 2/4/1] cas 0
[Sysname-cas 2/4/1:0] ani all
[Sysname-cas 2/4/1:0] ani-digit 3
Related commands
ani
answer enable
Use answer enable to configure the originating side to require the terminating side to send answer
signals.
Use undo answer enable to configure the originating side to not require the terminating side to send
answer signals.
Syntax
answer enable
undo answer enable