R0106-HP MSR Router Series Voice Command Reference(V7)

60
Views
R2 CAS view
Predefined user roles
network-admin
Usage guidelines
R2 signaling in some countries must support re-answer processing. When the terminating side sends a
clear-back signal, the originating side does not release the line, but maintains the call state. If it receives
a re-nswer signal from the terminating side within a specified time, it continues the call. Otherwise, it
disconnects the call upon timeout.
Examples
# Enable reanswer signal processing on the originating side.
<Sysname> system-view
[Sysname] controller e1 2/4/1
[Sysname-E1 2/4/1] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-E1 2/4/1] cas 0
[Sysname-cas 2/4/1:0] re-answer enable
register-value
Use register-value to configure a register signal value.
Use undo register-value to restore the default.
Syntax
register-value { billingcategory | callcreate-in-groupa | callingcategory | congestion |
demand-refused | digit-end | null-number | req-billingcategory | req-callednum-and-switchgroupa |
req-callingcategory | req-currentcallednum-in-groupc | req-currentdigit | req-firstcallednum-in-groupc
| req-firstcallingnum | req-firstdigit | req-lastfirstdigit | req-lastseconddigit | req-lastthirddigit |
req-nextcallednum | req-nextcallingnum | req-switch-groupb | subscriber-abnormal |subscriber-busy
| subscriber-charge |subscriber-idle } value
undo register-value { billingcategory | callcreate-in-groupa | callingcategory | congestion |
demand-refused | digit-end | null-number | req-billingcategory | req-callednum-and-switchgroupa |
req-callingcategory | req-currentcallednum-in-groupc | req-currentdigit | req-firstcallednum-in-groupc
| req-firstcallingnum | req-firstdigit | req-lastfirstdigit | req-lastseconddigit | req-lastthirddigit |
req-nextcallednum | req-nextcallingnum | req-switch-groupb | subscriber-abnormal |subscriber-busy
| subscriber-charge |subscriber-idle }
Default
The register signal values depend on the R2 signaling standard (configured by using the mode
command).
Views
R2 CAS view
Predefined user roles
network-admin