R0106-HP MSR Router Series Voice Command Reference(V7)

70
release-guard time: Specifies the timeout time of release guard signals, in the range of 100 to 60000
milliseconds. The originating side starts this timer after sending a clear-forward signal. If it does not
receive a release guard signal from the terminating side before the timer expires, it clears the connection.
This option applies to the originating side.
seizing time: Specifies the timeout time of seizure signals, in the range of 100 to 5000 milliseconds. The
originating side starts this timer after sending a seizure signal. If it does not receive a seizure
acknowledgement signal or an answer signal from the terminating side before the timer expires, it clears
the connection. This option applies to the originating side.
Examples
# Set the timeout time of seizure signals to 300 milliseconds.
<Sysname> system-view
[Sysname] controller e1 2/4/1
[Sysname-E1 2/4/1] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-E1 2/4/1] cas 0
[Sysname-cas 2/4/1:0] timer dl seize 300
timer dtmf-delay
Use timer dtmf-delay to configure the delay from when the originating side receives a seizure
acknowledgement signal to when it sends DTMF tones.
Use undo timer dtmf-delay to restore the default.
Syntax
timer dtmf-delay time
undo timer dtmf-delay
Default
The delay is 50 milliseconds.
Views
R2 CAS view
Predefined user roles
network-admin
Parameters
time: Specifies the delay before sending DTMF tones, in the range of 50 to 10000 milliseconds.
Usage guidelines
You can configure a delay to send DTMF tones for digit collection on the remote PBX.
This command takes effect only after you configure the dtmf enable command.
Examples
# Configure the delay for the originating side to send DTMF tones as 800 milliseconds.
<Sysname> system-view
[Sysname] controller e1 2/4/1
[Sysname-E1 2/4/1] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-E1 2/4/1] cas 0
[Sysname-cas 2/4/1:0] dtmf enable