R0106-HP MSR Router Series Voice Configuration Guide(V7)

98
Configuring UDP or TCP for outgoing SIP calls
Specifying UDP or TCP as the global transport protocol
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter SIP view.
sip N/A
4. Specify UDP or TCP as the
global transport protocol for
outgoing SIP calls.
session transport { tcp | udp }
By default, UDP is used as the
global transport protocol.
Specifying UDP or TCP as the transport protocol on a VoIP entity
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Enter VoIP entity view.
entity entity-number voip N/A
5. Specify UDP or TCP as the
transport protocol for outgoing
SIP calls.
session transport { tcp | udp }
By default, the default global
transport protocol (UDP) is used.
Enabling the UDP or TCP listening port
To receive the packets transported over UDP or TCP, enable the UDP or TCP listening port.
To enable the UDP or TCP listening port:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter SIP view.
sip N/A
4. Enable the UDP or TCP
listening port.
transport { tcp | udp }
By default, both the UDP and TCP
listening ports are enabled.
The undo transport command
removes established connections.
Setting the aging time for TCP connections
Perform this task to specify the amount of idle time that elapses before a TCP connection is removed.
To set the aging time for TCP connections: