R0106-HP MSR Router Series Voice Configuration Guide(V7)

14
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E&M interface view.
subscriber-line line-number N/A
3. Configure the immediate start
mode for the E&M interface.
signal immediate
The default is the immediate start
mode.
4. Configure a delay for the
originating side to wait to send
DTMF tones in immediate start
mode.
delay send-dtmf milliseconds
The default is 300 milliseconds.
Use this command on the
originating device.
To configure the delay start mode:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice interface view.
subscriber-line line-number N/A
3. Configure the delay start mode for the
E&M interface.
signal delay
The default is the immediate
start mode.
4. Configure the seizure signal duration in
delay start mode.
delay hold milliseconds
The default is 400 milliseconds.
Use this command on the
terminating device.
5. Configure the delay time from when the
terminating side detects a seizure signal
to when it sends the seizure signal in
delay start mode.
delay rising milliseconds
The default is 300 milliseconds.
Use this command on the
terminating device.
To configure the wink start mode:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice interface view.
subscriber-line line-number N/A
3. Configure the wink start mode for the
E&M interface.
signal wink
The default is the immediate start
mode.
4. Configure the delay time from when
the terminating side receives a
seizure signal to when it sends a
wink signal in the wink start mode.
delay send-wink milliseconds
The default is 200 milliseconds.
Use this command on the
terminating device.
5. Configure the duration of a wink
signal sent by the terminating side in
wink start mode.
delay wink-hold milliseconds
The default is 500 milliseconds.
Use this command on the
terminating device.
6. Configure the timeout time for the
originating side to wait for a wink
signal after sending a seizure signal
in the wink start mode.
delay wink-rising milliseconds
The default is 2000
milliseconds.
Use this command on the
originating device.