R0106-HP MSR Router Series Voice Configuration Guide(V7)

[RouterA-voice] dial-program

[RouterA-voice-dial] entity 1001 pots

[RouterA-voice-dial-entity1001] match-template 0101001

[RouterA-voice-dial-entity1001] line 2/1/1

2. Configure Router B:

# Configure the called number as 010 for VoIP entity 010, and configure the destination IP

address as 1.1.1.1.

<RouterB> system-view

[RouterB] voice-setup

[RouterB-voice] dial-program

[RouterB-voice-dial] entity 010 voip

[RouterB-voice-dial-entity10] match-template 0101001.

[RouterB-voice-dial-entity10] address sip ip 1.1.1.1

[RouterB-voice-dial-entity10] quit

# Configure the local number as 07552001 for POTS entity 2001, and bind FXO interface line

2/1/1 to POTS entity 2001.

[RouterB-voice-dial] entity 2001 pots

[RouterB-voice-dial-entity2001] match-template 07552001

[RouterB-voice-dial-entity2001] line 2/1/1

# Configure the number sending mode as all.

[RouterB-voice-dial-entity2001] send-number all

Verifying the configuration

# Dial 07552003 from Telephone B.

# After hearing a dial tone, dial 0101001 (Telephone A) from Telephone B to verif y that Telephone B can

establish calls with Telephone A through two dials.

FXO interface PLAR configuration example

Network requirements

As shown in Figure 10, Router A and Router B are connected through an IP network and can reach each

other. The PBX is configured with a trunk number 07552003.

Configure PLAR for the FXO interface of Router B. When the user of Telephone B dials 07552003, the

FXO interface automatically calls Telephone A.

Figure 10 Network diagram

Configuration procedure

1. On Router A, configure the local number as 0101001 for POTS entity 1001, and bind FXS

interface line 2/1/1 to the POTS entity.

<RouterA> system-view

[RouterA] voice-setup

[RouterA-voice] dial-program