R0106-HP MSR Router Series Voice Configuration Guide(V7)

42
• segment—After receiving the called number, the terminating side directly returns the "called party
idle" interregister signaling, without waiting for the real state of the terminating side. If the called
party is busy, the terminating side plays busy tones to the originating side.
To configure the connection mode:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1 or T1 interface view.
controller { e1 | t1 } number N/A
3. Create a timeslot set and
enable R2 signaling for it.
timeslot-set ts-set-number timeslot-list
timeslots-list signal r2
By default, no timeslot set is
created.
4. Enter R2 CAS view.
cas ts-set-number N/A
5. Configure the connection
mode.
callmode { terminal | segment }
By default, the terminal
mode is used.
Maintaining specified timeslots
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1 or T1 interface view.
controller { e1 | t1 } number N/A
3. Create a timeslot set and
enable R2 signaling for it.
timeslot-set ts-set-number timeslot-list
timeslots-list signal r2
By default, no timeslot set
is created.
4. Enter R2 CAS view.
cas ts-set-number N/A
5. Maintain specified timeslots.
ts { block | open | query | reset } timeslots
timeslots-list
N/A
Configuring R2 digital line signaling
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1 or T1 interface view.
controller { e1 | t1 } number N/A
3. Create a timeslot set and
enable R2 signaling for it.
timeslot-set ts-set-number
timeslot-list timeslots-list signal r2
By default, no timeslot set is
created.
4. Enter R2 CAS view.
cas ts-set-number N/A
5. Configure the originating side
to require the terminating side
to send answer signals.
answer enable
By default, the originating side
requires the terminating side to
send answer signals.
6. Enable reanswer signal
processing on the originating
side.
re-answer enable
By default, reanswer signal
processing is disabled on the
originating side.
7. Configure the terminating side
to send clear-back signals
when the originating side first
disconnects the line.
clear-forward-ack enable
By default, the terminating side
does not send clear-back signals
when the originating side first
disconnects the line.