R0106-HP MSR Router Series Voice Configuration Guide(V7)

73
[RouterA-voice-line2/1/1] substitute called 1
When you use Telephone A to call number 0101001, FXS interface 2/1/1 replaces 0101001 with 1001
and sends the call to the destination address 1.1.1.2. Then Telephone B rings.
Configuring a priority for a voice entity
If a number matches multiple voice entities, the router selects the voice entity with the highest priority.
To configure a priority for a voice entity:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Enter voice entity view.
entity entity-number { pots | voip }
N/A
5. Configure a priority for the
voice entity.
priority priority-order The default priority is 0.
Configuring the voice entity selection order
If a number matches multiple voice entities, the router selects a voice entity based on the configured
selection order.
To configure a voice entity selection order:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Configure a voice entity
selection order.
entity hunt hunt-number
The default hunt-number is 0,
which specifies longest match,
voice entity priority, and random
selection. For information about
these selection rules, see this
command in Voice Command
Reference.
Configuring a number sending mode
The number sending mode controls how the originating router sends a called number. The router
supports the following number sending modes:
• Sends the least significant digits of a called number. The number of the least significant digits is
specified with the send-number digit-number command.
• Sends all the digits of a called number.