R0106-HP MSR Router Series Voice Configuration Guide(V7)

74
• Sends a truncated called number. When the match-template command configured for a voice
entity contains dots ".", only the digits that match the dots are sent.
Procedure
To configure a number sending mode:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Enter POTS voice entity view.
entity entity-number pots N/A
5. Configure a number sending
mode.
send-number { digit-number | all |
truncate }
By default, the truncate mode is
used.
Examples
As shown in Figure 29, Router A and Router B connect to each other through an IP link and an E1 link.
The telephones at two sides call each other through the E1 link. This section provides examples for
configuring number sending modes to achieve different call policies.
Figure 29 Network diagram
Configuring basic settings
1. Configure Router A:
# Configure a timeslot set using R2 signaling for controller E1 2/4/1.
<RouterA> system-view
[RouterA] controller e1 2/4/1
[RouterA-E1 2/4/1] timeslot-set 0 timeslot-list 1-31 signal r2
[RouterA-E1 2/4/1] quit
[RouterA] voice-setup
[RouterA-voice] dial-program
# Configure a match template to match 010….$ for POTS entity 1001 and bind line 2/4/1:0 to
the entity.
[RouterA-voice-dial] entity 1001 pots
[RouterA-voice-dial-entity1001] match-template 010....$
Router A
Router B
E1 2/4/1
2000
1001
0101001
Telephone A
Telephone B
Telephone C
Telephone D
01001
E1 2/4/1
FXS2/2/1
FXS2/2/1
FXS2/2/2
FXS2/2/3
GE2/1/1
1.1.1.1/24
GE2/1/1
1.1.1.2/24